Francois Mevs

Check magnet under snowmen. Measure at main board J9 or J10 for 0v. Reference ground from black/white or black wire on J9 or J10. If 5v present, magnet is not engaging CG2012BLX sensor below snowme...

Please click here to download the latest manual and system schematic. 

Swap J13 with J12. If the problem was with the bottom shelf, did the problem remain at bottom shelf? If yes, either missing +12 at motor, harnessing from J13, pin 2 to ground side of motor is bad, ...

if the down the clown shelf reset motor keeps running when there are no clowns knocked down you could be experiencing a problem with the shelf position sensor, check the PDF below for troubleshooti...

The game has a passive infrared sensor (PIR sensor) located in the top of the canopy to detect people trying to climb in the game to cheat. When the sensor senses a change in an object’s temperatur...

During normal game play the clown on the marquee moves to the appropriate balloon level position based on the end of game score. If during power on cycle or at the end of a game the clown in the ba...

The game will display “TIC” on your score display when the game has tried to pay tickets but has not seen the sense signal from the ticket dispenser change state. Here are some steps to trouble sho...

Please click here to download the latest manual, LED install instructions, and the system schematic.  

To enter Error display mode, please press the UP push button located on the lower center door when in attract. To exit this mode press the UP button again.  Error Codes for Down the ClownError 1 Ti...

When playing the game the main board looks at the signal lines for the clown scores sensors if  2 complete rows of clowns are knocked down the main board will send a signal to  lift the clowns back...