Francois Mevs

Monopoly Roll N Go has used two different models of computers.  Original games used a HP G4 and current production games use a Lenovo M70t, the BIOS settings for each configuration is below.  If a ...

NBA hoops uses a series of RJ45 network lines connected to the time display board to communicate.  See the file below for a layout of the connections. 

The ball gate on NBA Hoops is driven by the main board located in the front podium and connected to the J13 socket. The open and closed switches on the ball gate motor are connected in the normal...

NBA Hoops uses an infrared red sensor to detect the ball entering the hoop.  The sensor is connected to the J1 connector on the back side of the time display board.  The newest revision of net sens...

Please click here to download the latest manual and system schematic.  

The All In game uses a solenoid to lock the handle in place when the game is not coined up.  When the solenoid is disengaged the latch is up preventing the handle from being pulled.  When the latc...

Below is the full listing of the error codes for the All In game.  

Below are the instructions sowing how to replace the shooter assembly on All In. 

We have updated the power supply used to power the Raspberry Pi in the All In game.  We have determined that isolating the power for the Pi from the game power has improved the stability of the pi....

All In uses a linear actuator to raise and lower the playfield when the game is powered on.   The actuator is located in the middle of the game on the bottom side of the playfield.  The actuator i...