Francois Mevs

Check magnet under clowns. Measure at main board J8, J9, or J10 for 0v. Reference ground from black/white or black wire on J8, J9, or J10. If 5v present, magnet is not engaging CG2012BLX sensor bel...

If your ball gate  works for a period and stops or works once and stops the game is not seeing either the open sensor or the closed sensor for the ball gate.   When the game is first powered on the...

Please click here to download the latest manual and system schematic. 

The landing position on Monopoly Roll N go can be adjusted using the game software to allow it to better match up to the arrows on the cabinet.  To adjust the position access the game programming m...

Monopoly Roll N go uses and optical encoder to senses the movement of the di on the game.  The right side of podium has access to the encoder disc and sensor. Check to ensure disc is centered to se...

The ticket run line for Monopoly roll N Go comes from the P4 connector on the I/O board.  When referenced to ground and the game is trying to pay tickets you will have 5vdc, if the voltage is not p...

When using coins on Monopoly Roll N Go the coin switch should be wired in the normally closed state.  Wiring the switch signal line to normally open will cause inconsistent coin up.   

If your Mega Marquee diamond is upside down you can flip it in the game software, see below for  instructions on how to flip it.       

If your video for either of the monitors upside down you can adjust the monitor settings in the control panel to change the orientation of the monitor. 

When installing a new Samsung monitor to your game you will need to make a few adjustments to the settings of the monitor.  Failing to setup the monitor will result in the game intermittently not s...