David M. Bartel

When removing the side panel to access the score sensor the start button wiring might come unplugged. The picture shows the two wires for both sides on how they should connect to the switch.   Blac...

A possible fault condition can occur that results in damage to the goalie bumper assembly or slider.  We recommend updating the software to version 1.09.  This new version will activate upon sensor...

It has been determined that sensors used for the goalie travel might be of the wrong type.  Sensors that detect the travel of the goalie should be of a fine focus type of sensors.  The manufacturer...

Although more than six balls where included with your game, you should never have more than six in play.  Adding more balls to the game will cause ball jams and unnecessary down time.  Be sure to c...

The game has a built in diagnostic menu to show the status of all sensors and switches.  This menu also shows which boards are not communicating with each other.  If no cheat sensor option has been...

If you game experiences a "blocked Goal, call tech" error or "call tech, left (or right) 1 (or 2) blocked see the pdf below.

1.05 introduces changes to error conditions. Soft errors (recoverable) vs. hard errors (fatal). A change was made that adjusted how error 1 works.  If a ball is attempted to be dispensed 2 times in...

During shipping it might be possible for the brushes to eject from their mounts.  The result is a dead goalie motor.  It is very easy to correct.  The back of the motor has a plastic cover which ne...

How to remove the goalie motor from your game.

Please click here to download the latest manual and system schematic.